Architectural Dimensional Letters, Cast Plaques & Commercial Sign Systems

Concealed Stud Mounting & House Number Installation

Every order includes threaded stainless rear studs. Walking through this four-step installation overview helps determine whether you should add a full-scale paper drilling template, standoff spacers, and mounting adhesive to your order.

Included & Optional Mounting Hardware

Four-Step Concealed Stud Installation Sequence

Step 1: Level & Tape the Pattern

Position the full-scale mounting template on stucco, brick, stone, wood, or siding where the address will sit. Check horizontal level and tape the pattern securely flat against the wall.

Level and tape house number mounting template to exterior wall

Step 2: Drill Stud Holes & Remove Pattern

Drill pilot holes directly through the marked stud coordinates on the pattern using the appropriate masonry or wood bit, blow out dust, and peel off the paper template.

Drill holes through marked stud centers and remove paper template

Step 3: Apply Adhesive & Optional Spacers

Fill the drilled holes with exterior construction epoxy, coat the threaded rear studs, slide optional anodized aluminum spacers onto each stud if floating stand-off relief is desired, and press firmly into the wall.

Apply adhesive, slide standoff spacers onto studs, and seat letters

Step 4: Clean Architectural Result

Allow adhesive to cure per manufacturer directions and remove any painter's tape. Your numbers remain securely anchored with zero visible screw heads.

Finished concealed stud house number installation with crisp shadow relief

Need Standoff Spacers or Custom Pattern Spacing?

Contact us at 818-503-9472 or sales@westonletters.com, or select accessories online at ArchitecturalNumbers.com.

Configure Hardware Online →